Search Results

Massive integration of inverter dominated renewable energy systems (RESs), i.e., wind turbines (WTs), reduces the reliance on conventional alternator-based power stations. The system inertia and damping aspects of the power system were significantly decreased by this extensive integration of inverter-based WT system, which impacts on the fault ride-through (FRT) competence and thus precipitates the frequency…

This paper looks for the merging of solar PV power plant with thermal power generation and interlinked through tie-lines approaching into an interlinked PV-Thermal model for the design and analysis of load frequency controllers. Moreover, the different models of controllers are also proposed and tested to regulate the frequency of PV-Thermal interlinked system for a…

The impact of previous energy crisis gives an insight into what happens when the oil price crashes. Μany countries were affected due the slow reaction in boosting the economic growth in key sectors such as oil-importing activities and the economic restructuring progress to face the challenges. But the present energy crisis resulting from the COVID-19…

In this paper, an improved model has been proposed for investigating the impact of cyber-attacks on power systems regarding frequency disturbances and voltage disruption while changing the load called ICAPS. The proposed ICAPS model is formulated by five different controllers, such as LFC, AGC, AGC-PID, AVR, and AVR-PID, implemented in two sets of the system…

There are different factors which contribute to the amount of output power which can be delivered by solar photovoltaic (PV) module at any time of the year. The factors include but not limited to solar irradiation, ambient temperature, relative humidity, wind velocity, position of sun in the sky, geographical position of installed solar PV module…

DC Microgrids (DCMGs) aggregate and integrate various distribution generation (DG) units through the use of power electronic converters (PECs) that are present on both the source side and the load side of the DCMGs. Tightly regulated PECs at the load side behave as constant power loads (CPLs) and may promote instability in the entire DCMG.…

This paper presents novel Energy Management Strategies (EMSs), and the control of a Grid-Connected Hybrid Renewable Energy System (GCHRES). The GCHRES describes a Photovoltaic Generator (PVG) and a Battery-Based Storage System. Both are tied to the Common Coupling Point (CCP) through a reversible three-phase inverter. The CCP combines the Utility Grid (UG) and an AC…

The transmission network has been considered among the globe’s prevalent complex systems, comprised of hundreds of electrical transmission lines and other equipment used to transmit electrical energy from one location to another. Over a decade, power engineers have worked tirelessly to ensure that the transmission network operates reliably, transmitting electrical energy from the power station…

Nowadays, LED lights take an important place in our daily lives and they have known a great growth in indoor as well as in outdoor lighting applications. LED (Light Emitting Diode) light sources including their own drivers have excluded many systems fitted with both inefficient light sources. In this paper we present, a LED driver…

In this paper, second order generalized integrator (SOGI) is discretized to design the control algorithm of unified power quality conditioner (UPQC). A UPQC is combination two voltage source converter (VSC) and VSC are connected with back to back DC link. The first one VSC is in series to maintain the desire voltage at point of…

It is widely known that cities now house more than half of the world’s population. Within this framework, this study presents the possibilities for real-world application of renewable energy sources (RES) in urban areas, as well as their contribution to the urban deployment of the new energy paradigm. A comparison is made between hybrid power…

In this work we discuss a special technique for powering of sensor systems, based on a low-power primary cell consisting of two electrodes, made from different metals, with water (lake, rain or tap water) used as an electrolyte. Once placed into an aqueous solution, the primary cell generates a small electric current, which may be…

In this work, the impact of implementing a large amount of decentralized renewable energy sources (RES) of different scales on an extra-large power grid is investigated. Three scenarios are created, substituting 10%, 20%, and 30% of the conventional energy production by RES. For this purpose, the initial dynamic model of Continental Europe in combination with…

There is no doubt that energy is one of the most important requirements of life, and its importance increases with the passage of time, and this is what make countries to harness the capabilities and scientists in developing energy systems of all kinds, one of the most important energy systems these days is what is…

Transformers are habitually designed and manufactured for operation at a fundamental frequency of 50Hz and sinusoidal load current. Transformers are susceptible to non-linear loads. The inception of switching action characterises Non-linear loads and consequently nonsinusoidal load current which brings about higher transformer service losses, hotspot temperature rise, and degradation of cellulosic and liquid insulation, and…

The effectiveness and suitability for the reliability and test of the embedded software of the automotive EHPS (Electrical Hydraulic Power Steering) pump are extensively explored in this paper. The Crow-AMSAA analysis has been applied to evaluate the embedded software reliability growth based on the failure data collected in the prototype phase and in the field.…

During the past years, a lot of research work have been done on the topic of smart grids and more specifically on the charging of electric vehicles (EVs), which will become an essential aspect in the coming years. The various works carried out on these themes have allowed the development of efficient tools to organize…

Distributed Solar Photovoltaic (DSP) Plants are one of the fastest growing renewable energy systems in South Africa. The primary components forming an integral part of the point of common coupling (PCC) are, the inverter used to convert dc voltage to ac voltage and step-up transformers which step-up low voltage input to the desired output level.…

The rapid transformation of the energy sector in South Africa towards renewable energy (RE) production calls for the management of assets to keep pace with the ongoing developments in a reliable manner. Aging assets, increasing energy needs and reliable supply of energy without load shedding are some of the challenges utilities are facing in South…

Fuel Cells (FCs) and Combined Cooling, Heating and Power (CCHP) systems are becoming very popular due to their environmental friendliness and immense applications. This extended review paper commenced by introducing the rampant South Africa’s electricity crisis as the basis for the study, followed by some structural analyses of up to forty-four miscellaneous power electronics converters…

The design, fabrication and testing of a power availability recorder (PAR) to track the duration of electricity supply in facilities is presented. The design was executed with C-Language encoded in a microcontroller which served as the central processing unit of the device. Proteus software was, subsequently, used to simulate the real-life practicability of the device…

This paper presents a new observer-based method which deals with the extraction of amplitude of characteristic frequencies for the fault diagnosis in permanent magnet synchronous motors (PMSM). First, a pilot survey is made to investigate the typical harmonics in the line currents of PMSM. Second, an appropriate structure of observer is formulated with the input…

Light Emitting Diode (LED) lamps are used as a replacement of “old-fashioned” or incandescent lighting sources, as they reduce the amount of energy consumed. As a side-effect of more efficient energy usage they produce electrical noise. This noise reduces the efficiency of information signal transfer when Power Line Communications (PLC) are used. This study focuses…

Waste is currently a serious problem often found in rural areas, rural areas, and even industrial areas. Waste is a side effect of activities carried out by humans to meet social or industrial needs. Increasing human productivity will also increase the amount of waste produced. To overcome this, a sorting management system is needed. Good…

Induction motors (IM) are used widely in high energy applications where high torque is required such as ships/ aircrafts manufacturing industry. Those motor drivers are populated in many advantages especially their wide control strategies. However, new technology is invented for enhancing efficiency and smoothing the torque curve by increasing number of phases in the motor…